How To Install A Single Processor; Installing A Single Processor - Intel MS440GX Product Manual

How to Install a Single Processor

Procedure To: Install a Single Processor
Step Action
1 Observe the safety precautions in Safety Considerations at the beginning of this chapter.
2 Turn OFF the computer.
3 Disconnect the computer's power cord and all external peripheral equipment.
4 Remove any peripherals that block access to the P0 processor's Slot 2 connector.
5 Remove the antistatic packaging from the new processor.
6 Secure a DRM top (D) to the processor by snapping the clips (H1 and H2) into the holes on each
side of the processor.
7
Orient the P0 processor
8
Slide the processor into the retention mechanism
9 Press down firmly on the processor until it is seated in the P0 processor Slot 2 connector (G) and
fasten with screws.
10 Lock down DRM top into retainer clips (F) on tops of DRM bases with 6-32x1/2 inch screws (C).
11 If there is no Termination Card in the P1 processor Slot 2 connector then install one using the
procedure entitled "How to Install a Termination Card".
12 Replace any peripheral equipment that was removed in Steps 3 and 4 above.
13 Set the processor speed using the procedure entitled "How to Set the Processor Speed".
(A
) so that the heat sink (B) is closest to the DIMM sockets.
(E).
H1
A
B
F
G
E
DIMM Slots
Figure 4.
Installation and Removal Procedures
C
D
H2
E
OM08284
37