3H. Procedure Step 16: Processors Installed In The Drm - Intel MS440GX Product Manual

Procedure (continued)
Step Action
15 Secure the other DRM top to the processor with the holes facing toward the DIMM slots.
NOTE
If using a Termination Card, then secure the DRM top to the card in the same manner.
The DRM top is necessary to lock the Termination Card down and provide a way to remove it
from the connector by pulling it up and out.
16 Install the two processors (CPUs) in the DRM with the heat sinks facing the DIMM slots.
NOTE
Check hole placement of the DRM top relative to the retainer clip holes before installation
to ensure correct alignment. Use 4 ½ inch screws to secure tops to retainer clip.
DRM Top
Retention Hole
Heatsink
DIMM Slots
Installation and Removal Procedures
DRM Top
Retention Clip
Dual Retention Mechanism (DRM)
Processor (CPU) Connector
D
OM08285
Figure 3h.
Continued
35