How To Install The Processor And The Grounded Processor Retention Mechanism; Install The Grounded Processor Retention Mechanism; Installing The Processor Retention Mechanism - Intel cc820 Product Manual

Intel Desktop Board CC820 Product Guide
How to Install the Processor and the Grounded
Processor Retention Mechanism
Follow these instructions, to install the processor:

1. Install the grounded processor retention mechanism.

2. Install the processor.
Detailed instructions follow for each of these procedures.
Install the Grounded Processor Retention Mechanism
The grounded processor retention mechanism (GRM) can be used with either a Pentium III or
Pentium II processor in a SECC2 package. The GRM is shipped as two assemblies that are ready
for installation on the desktop board. As shown in Figure 10, each assembly consists of a gray,
notched (E) retention bracket (A), a black, unnotched retention bracket (B), two press-fit fasteners
(C), and two fastener retainer pins (D).
Follow these steps to install the assemblies on the desktop board:
1. Support the desktop board so it will not deform when a fastener is pressed into its mounting
hole. There must be at least ½ inch (1.27 cm) of free space under each mounting hole.
2. One retention bracket (A) is gray; the other (B) is black. The gray retention bracket is notched
(E) to fit over the key (F) on the end of the 242-contact slot connector near the center of the
desktop board. As shown in the Figure 10, align the notched retention bracket over the
mounting holes on the desktop board.
3. Press down on the bracket until each of the two fasteners (C) snap into place in the mounting
holes on the desktop board. Confirm that both sides of the retention bracket are seated against
the desktop board before proceeding.
30
A
E
F
Figure 10. Installing the Processor Retention Mechanism
D
C
B
OM08857