Table of Contents
Advertisement
Available languages
Available languages
OPERATION
Controls
The hood is operated using the slide controls
under the bottom of the hood.
The light switch turns the lamps on and off.
The blower switch :makes it possible to select
the motor operating speed. Position 0: motor
off.
The pilot lamp lights up whenever the blower
is on.
LIGHT
BLOWER
SWITCH
SWITCH
PILOT LAMP
HEAT SENTR yTM
Your hood is equipped with a HEAT SENTRY
TM
thermostat. This thermostat is a
device that will turn on or speed up the blower if it senses excessive heat above
the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature
level drops to normal, the blower will return to its original
setting.
WARNING
The HEAT SENTRY thermostat
can start the blower even if the hood is turned
OFF. When this occurs, it is impossible
to turn the blower OFF with its switch.
If you must stop the blower, do it from the main electrical
panel.
HALOGEN
BULBS
This range hood requires two halogen bulbs
(Type JC, 12Vott, 20 Watt Max, G-4 Base).
ALWAYS SWITCH OFF THE ELECTRiCiTY
SUPPLY
BEFORE
CARRYING
OUT ANY
OPERATIONS ON THE APPLIANCE.
To change bulbs:
1. Open the cover by prying from the proper
slots. - DO NOT ROTATE. CAUTION: BULB
MAY BE HOT!
2. Replace with a Type JC, 12Vott, 20 Watt
Max,
G-4
Base
bulb.
Do not touch
replacement
bulb with bare hands! If the
bulb is touched with the bare hand, it should
be cleaned with a lint-free cloth moistened
with rubbing alcohol.
o
-9-
Advertisement
Table of Contents
