Reversing The Door Swing - GE Spacemaker DSXH47 Owner's Manual & Installation Instructions

Installation Instructions
GAS CONNECTION FOR
GAS DRYERS
1. Remove the shipping cap fl-om gas pipe at the rear of
the d13e_;
Conversion to LP Gas: DO NOT connect the (hTer to
LP gas selvice without converting lhe gas _dxe. An I3)
come_sion kit (Pub. No. 14-A038) MUST be installed
by a qualit]_ d gas technician.
a. (:onnect a 1/2" (1.27 cm) I.I). semi-rigid or approved
pipe from gas supply line to the 3/8" (0.1)6 cm) pip(
located on the back at the duel: [sea 1/2" to 3/8"
(1.27 cm 1o 0.96 cm) reduc( r t_n a connection.
Apply _ln approved lhread se_der their is resistant
to the corrosixe a(fion at liquefied gases on all
pipe connections.
b. Open the shutot] _dve in the gas supply line.
c. "I_:'stall connections by I)_ushing Oll a soal)y water
sohltion.
WARNING: NEVER'I ZST
FOR GAS LF.,AKS WITH AN
OPEN 1,IAME.
2. Connect th{ _. x haust (hlct lt_ olltside (xhaust system.
I se duct rope to seal all.joints.
3. With the dlTer in its final position, av!just one or more
of the legs until lhe dlTer is resting solidly on all timr
legs. Place a level on lop of' lhe duel: THE DRYER
MUST BE LEVEL AND RESTING SOLIDLY ON
ALL FOUR LEGS.
4. Plug the pow(r cord into a grounded outlet.
NOTE: Check to en,,ure the power is attar circuit
breakerifilse box befit)re phlgRing the power cord
into the outlet.
5. Tt/rn on the power at the circuit breaker/fHse box.
.& CAUTION:
ol,e, ti. the,
make sul-( the dla'er area is clear and kS-(e1S-am
Colnlmstible mamrials, gasoline, and oth(r flammable
v;ipors. _klsosee lhat l_othing (such as boxes,
clothing, etc.) obstlucts the flow of combustion
and wqltilation ai_;
6. Run tile d_yer through a c_cle check for proper
Ol)eration.
NOTE: On gas (hTel% 1)eti)re the burner will light, it is
n(cessal) tin- th{ gas line to b( Ned of ain It tile burner
do(!s liar light within 43 seconds th{ fip, t time the d13er is
ulrne(I on, the satbt)" swit(h will shut the burner ot1_ It this
lmpp(ns, ttlrn tile timer to OFF and wait 5 minut(s l>et;._re
making another attempt to light.
7. If)our dlTer does not opel_txe, please review the
Troubleshooting 77pssection in this manual betin-e
(ailing f)_r seP,'ice.
8. Place these instructions in a location near the dlTer for
filture l-efkq>nce.
REVERSING THE DRYER
DOOR SWING
1. ()pen the dicer dool: Remove the 4 hinge hole plugs or
screws from th_ l_ft si(l_ of door opel_ing. Plac( nearb?
tiw fimlre installation. NOTE: Youmay need a plastic knife
to help pull out the plugs. Be careful not to scratch the paing
2. Remove the t;mn-screws that secure the door hinges to
the d_Ter l¥ont panel. NOTE: Remove I screw from each
of the 2 hinges firsg Hold the door firmly before romouthg the
last 2 screws.
3. Rotate the door l S0 ° and reinstall lhe door hinges to the
(h3er h-_mt panel with the 4 screws.
4. Install the 4 hinge hole plug', or screws that were
removed in step 1 into lhe open screw holes on the Hght
side of the door opening.
Remove 4 scr_w_one from eachhingefirst
18