GE Spacemaker DSXH47 Owner's Manual & Installation Instructions page 10

Installation Instructions
TOOLS AND MATERIALS
YOU WILL NEED
F1 Phillips head screwdriver
0 .\t!justable pliers (a(!just leveling legs)
F]I C_llpenttT'S
lexel
V] Flat or swaigbt blade screwdriver (ma} b( needed
for coM su;fin relie0
V] Duct tape
F] Ri_M or t IAisted flexible metal 4" (10.2 cm) duct
V1 Vent ho_M
FI 1/4" nut diner (remow' terminal block access
c(wer and install toM) (ELECTRIC DRYER)
F1 Pipe thread s_ aler (GAS DRYER)
V1 L IAismd strain reli_ f (may be supplied
with cord)
V3 L IAiswd 30A, 240"L 3-wire, #10 AWG minimum
conducu)r power coM (existing structln-( )
F1 [ Misted 30A, 240";, 4-Mrc, #10 AWl;
minimmn conduclt_r po'_xer COld is, required
(n_w consmlction)
F] Flexible staink ss steel or plastk-coated brass
connnecting robe (if' allow(d by building code)
(GAS DRYER)
V] Open-end wrenches tot flexible robe and
connector (GAS DRYER)
PREPARING THE INSTALLATION SITE
AND UNPACKING YOUR DRYER
1,
2.
3,
Prepare tile ar_a and exbaust tor installation
of lhe new dlyel;
Check to be sure that the existing <xternal
exhaust is clean and flint it m_els auached
installation specifications.
Place lhe four comer posls f'lxm_tile shipping
carton on tbe flool; parallel to each othen 2-3"
apart. C, a refillly la7,tile (hler on its left side oil
top of tim comer posts. Remove tile tbmn
shipping pad.
.& CAUTION:
"Ib prevenl damage, do
not use tile control panel as a re(arts 1o pick up
or move tbe &wel:
4. Reunn tile (hTer 1o all uprigbt position.
5. Move the dlTer 1o tile desired location.
6. Collll(Ct tim ext(lnal exbaust.
7. A_!just tbe leveling legs to match tbe washer
height. The dlwer nlust be level and rest tirmlv
on all four kw ling k_*.
8. Conn(cl tile pow(r supply.
9. Check the operation of lhe power supply and
venting.
10. Place the Owner's Manual and the Installatkm
lnsnuctions in a location where thev will be
notic(d b3 tile ownel;
10