Recording From Tape To Tape - Aiwa NSX-2700 Operating Instructions Manual

BASIC RECORDING
1
4
6
1
2
3
' 012PJl_l_d_
4
5
6
q4, I_1_
3
7
TAPE
i I
DUBBING SPEED
Q
r- t--t -- j.i Li .Ei
I
JJ LI .Ei
RECORDING FROM TAPE TO TAPE
Prepgr_tion
• Wind up the tape to the point recording starts.
• Note that recording is done on only one side of the tape.
• Use only normal (type I) tapes.
1
2
Press the TAPE button.
Insert the tape to be recorded on into deck 1.
Press the • / _ button to open the cassette holder.
Insert the tape with the side to be recorded on facing you and the
exposed side down.
Insert the original tape into deck 2, and wind up to
the point to be played back.
Press the • / _ button to open the cassette holder and insert
the tape with the exposed side down.
Check the playback side of the tape by pressing the • button
and wind up the tape with the qlql or _=,. button.
4 Select dubbing speed.
The dubbing speed can be selected by pressing the DUBBING
SPEED button. The following display shows the selected speed.
Each time the button is pressed, the display changes.
For dubbing at high speed: "H-DUB" is displayed.
For dubbing at normal speed: "TAPE" is displayed.
While"H-DUB" is displayed, the I_-, I_1_ and 41_1 button do not
operate.
5 Press the II button on deck 1.
6 Press the • button on deck 1.
The I_ button on deck 1 is depressed simultaneously, and
"RECORD" is surrounded by red in the display.
7 Press the I_ button on deck 2 to start recording.
The II button on deck 1 is released.
Playing and recording start simultaneously.
To stop recording
Press the • / __ buttons on both deck 1 and deck 2.
34