Table of Contents
Advertisement
To erase a recording
on that part of that tape.
Make sure the microphone is not connected to this unit.
1 Insert the tape you want to erase into deck 1.
2 Press the TAPE button and stop all the tape operation in deck
2.
3 Wind up the tape to the point where the erasure is to be
started.
4 Press the @ button on deck 1 to start erasure.
About cassette tapes
* To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
Type II ta
detection
slot
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type I (high/CrO2) tapes, take care
not to cover the Type II (high/CrOz) tape detection slot.)
* Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
COPYRIGHT
Please check the laws on copyright relating to recordings from
discs, radio or external tape for the country in which the
machine is being used.
RECORDING FROM TAPE TO TAPE
Preparation
« Wind up the tapes to the point to be played back and where
recording starts.
* Note that recording is done on only one side of the tape.
¢ Use Type I (normal) or Type II(high/CrOz) tapes for recording.
1 Press the TAPE button.
2 Insert the original tape into deck 2 and the tape
to be recorded on into deck 1.
Insert each tape with the side to be played back or recorded
facing out from the unit.
3 Select dubbing speed by pressing the DUBBING
SPEED button repeatedly.
For dubbing at high speed: "HIGH-DUB?' is displayed.
®
For dubbing at normal speed: "TAPE" is displayed.
buttons do not operate.
4 Press the Hl button on deck 1 then press the @
button.
The ® button on deck 1 is depressed simultaneously, and
is displayed. Deck 1 enters recording pause mode.
5 Press the ® button on deck 2 to start recording.
The Ill button on deck 1 is released.
Playing and recording start simultaneously.
To stop recording
Press the l/& buttons on both deck 1 and 2.
To cancel high-speed dubbing before recording
Press the DUBBING SPEED button again.
¢ When the high-speed dubbing mode is selected by pressing
the DUBBING SPEED button, only the @ bution functions
among the tape operation butions.
* Noise may be recorded if this system is too close to a TV, VCR
or radio. If this happens, move this system away from the TV,
VCR or radio.
12
Advertisement
Table of Contents
