Xerox WorkCentre 5020DN User Manual page 18

2 Product Overview
No. Component
2 Bypass Tray
3 Extension Flap
4 Access Cover 1
5 Access Cover 2
6 Document Feeder
7 Control Panel
8 Output Tray
9 Front Cover
10 Left Side Cover Latch
11 Tray 1
12 Paper Tray 2 (optional)
13 Stand (optional)
14 10Base-T/100Base-TX
Connector
15 USB Interface Connector
16 Connector
17 Power Cord Connector
18 Power Switch
18
Used for standard size paper and non-standard size paper. It holds
special media such as thick stock paper or other special media that
cannot be loaded in Tray 1 or Tray 2.
NOTE: For more information on the supported paper types and capacity
of the Bypass Tray, refer to
page 39
.
Supports paper that is loaded in the Bypass Tray. Slide out this flap
before loading paper in the Bypass Tray.
Open this cover to remove paper jams in and around Tray 1 and Tray 2.
NOTE: For more information on how to clear paper jams, refer to the
Problem Solving chapter in the System Administration Guide.
Open this cover to remove paper jams in and around Tray 2.
NOTE: The Access Cover 2 is a part of the optional Paper Tray 2.
NOTE: For more information on how to clear paper jams, refer to the
Problem Solving chapter in the System Administration Guide.
Automatically feeds documents that are loaded to be scanned for a copy
or a scan job.
Consists of the Display, the Machine Diagram (mimic), buttons and
indicators.
NOTE: For more information on the Control Panel, refer to
Panel on page 22
.
Copies and prints are delivered here, face down.
Open this cover to replace the Drum Cartridge and to add toner.
Pull up this latch to open the Left Side Cover.
Used for standard size paper. It holds up to 250 sheets of plain paper.
NOTE: For more information on supported paper types and tray
Supported Paper Sizes and Types on page 39
capacity, refer to
Adds an additional tray that can be used as Tray 2. Used for standard
size paper. It holds up to 500 sheets of plain paper.
NOTE: Paper Tray 2 is an optional accessory.
NOTE: For more information on supported paper types and tray
Supported Paper Sizes and Types on page 39
capacity, refer to
Elevates and stabilizes the machine for optimum use. The attached
casters allow you to move the machine easily.
NOTE: The stand is an optional accessory.
Connects the network cable to the machine.
Connects the USB cable to the machine.
NOTE: This connector is also used for upgrading software.
This connector is to be used only by customer engineers.
Connects the power cord to the machine.
Switches the power to the machine on and off.
Function
Supported Paper Sizes and Types on
Control
.
.