Switching On / Off; Switching On; Switching Off - Xerox WorkCentre 5020DN User Manual

Switching On / Off

This section describes how to switch the machine on and off, and explains the Power
Saver feature.
The machine is ready within 27 seconds after the machine is switched on. The time
required for the machine to warm up may vary, depending on the machine configuration
and the machine environment.
The machine automatically enables the Power Saver feature after a set period of
machine inactivity in order to minimize power consumption. It is recommended that the
machine be switched off at the end of the day or when it will not be in use for a long
period of time.
NOTE: If the machine is switched off, data currently being processed may be lost, and
all the scanned data stored in mailboxes will be deleted.
For information on the Power Saver feature, refer to

Switching On

The following procedure describes how to switch on the power to the machine.
1.
Press the Power Switch to the
[ ] position.
NOTE: [1] appears in the Display when the
machine is ready.
NOTE: If you attempt to run a job during
warm-up, the job will be processed once
the machine is ready.

Switching Off

The following procedure describes how to switch off the power to the machine.
NOTE: If the machine is switched off, data currently being processed may be lost, and
all the scanned data stored in mailboxes will be deleted.
1.
Before switching off the machine, make sure that all jobs have been processed
completely. Also, make sure that the <Online> indicator is not lit.
NOTE: Never switch off the machine in the following instances:
NOTE: Switching off the machine during copying or printing may cause paper jams.
• While data is being received
• While jobs are being printed
• While jobs are being copied
• While jobs are being scanned
Switching On / Off
Power Saver on page 36 .
35