High Beam Switch; Passing Light; Headlight Time Delay; Interior Lights - Jeep Automobile Owner's Manual

High Beam Switch

Pull the multi-function control lever towards you to
switch the headlights to "High" beam. The "High Beam
Indicator Light" on the instrument cluster will illumi-
nate. Pull the multi-function control lever a second time
to switch the headlights to "Low" beam.

Passing Light

You can signal another vehicle with your headlights by
lightly pulling the multi-function control lever toward
the steering wheel. This will cause the headlights to turn
on at high beam and remain on until the lever is released.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 119

Headlight Time Delay

There is also a feature that delays turning off the vehicle
lights for 30, 60, or 90 seconds after the ignition switch is
turned OFF. To activate the headlight delay, the multi-
function control lever must be rotated to the "Off"
position after the ignition switch is turned OFF. Only the
headlights will illuminate during this time. Refer to
"EVIC- Customer Programmable Features" in Section 4
to turn this feature "On/Off" or set the time interval.

Interior Lights

The interior lighting consists of courtesy lights mounted
below the instrument panel, an overhead console light
assembly which contains both driver and passenger
reading lights, reading lights located above the rear
doors, and a rear cargo light. Opening a door or turning
the center of the multi-function control lever to the
extreme up position will activate all interior courtesy
lights.
3