Canadian Programming/Gate Programming; Using Homelink - Jeep Automobile Owner's Manual

150 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
NOTE: To program the remaining two HomeLink but-
tons, begin with Programming step two. Do not repeat
step one. For questions or comments, please contact
HomeLink at www.homelink.com or 1-800-355-3515.

Canadian Programming/Gate Programming

Canadian radio-frequency laws require transmitter sig-
nals to time-out (or quit) after several seconds of
transmission which may not be long enough for
HomeLink to pick up the signal during programming.
Similar to this Canadian law, some U.S. gate operators are
designed to time-out in the same manner.
If you live in Canada or you are having difficulties
programming a gate operator by using the Program-
ming procedures (regardless of where you live), replace
Programming HomeLink step 3 with the following:
NOTE: If programming a garage door opener or gate
operator, it is advised to unplug the device during the
cycling process to prevent possible overheating.
3. Continue to press and hold the HomeLink button
while you press and release every two seconds ( cycle )
your hand-held transmitter until the frequency signal has
successfully been accepted by HomeLink. The EVIC
display will show "CHANNEL X TRAINED" (where X is
Channel 1, 2, or 3). Proceed with Programming step
four to complete.

Using HomeLink

To operate, simply press and release the programmed
HomeLink button. Activation will now occur for the
trained device (i.e. garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.). For convenience, the hand-held transmitter of the
device may also be used at any time. In the event that
there are still programming difficulties or questions,
contact HomeLink at: www.homelink.com or 1-800-355-
3515.