Advertisement
19. Install vinyl grip on lift handle as shown in figure 14.
20. Slide lift handle down between lift handle arm and
handle lock bracket. See figure 14.
21. Assemble lift handle to lift handle bracket using 3/8" x
3/4" clevis pin and 3/32" (small) hairpin cotter.
See figure 14.
LiFT HANDLE
SMALL HAiRPiN COTTER
!
HANDLE GRiP
HANDLE LOCK
BRACKET
LiFT HANDLE
ARM
FIGURE 14
CLEVIS PiN
LiFT HANDLE
BRACKET
22.
23.
24.
Raise and lock dethatcher in transport position (see
operation instructions on pages 9 and 10). Move
tractor with front mounted dethatcher onto a level
surface, such as a drive or garage floor. Lower the tine
dethatcher from transport position to rest on the level
surface.
Adjust tine shield until spring tines come in contact
with level surface, keeping front and back tines at
the same height. Tighten carriage bolts securing
mounting arms to angle brackets. See figure 15.
If you need more adjustment, try moving the axle
bushing up or down between the mounting arms. Be
sure to retighten the bolts securing the bushing.
MOUNTING
ARMS
AXLE
BUSHING
BRACKETS
FIGURE 15
Advertisement
