Led Worklight - Craftsman Professional 320.27311 Operator's Manual

USING THE LASER TRAC
TM
LASER LIGHT FEATURE (Fig° 8)
/_ WARNING:
LASER LIGHT. LASER RADIATIONo Avoid Direct Eye Exposure.
DO NOT stare into beam. Only turn laser beam on when the saw is on the workpieceo
Class itla laser°
NOTE:Your circular saw has a built-in laser light.To activate laser light switch,
saw must be plugged into power source.
2,,
3,,
4.
5.
6.
DO NOT turn the laser beam on until the saw
is on the workpiece.
Mark the line of cut on the workpiece
Adiust the cutting angle and cutting depth
as needed..
Plug in the saw and push the laser switch
forward to turn on the laser.
Align laser beam with line-of-cut (see Fig 8).
Squeeze the trigger switch and slowly push
the saw forward using both hands..Keep the
red laser beam on the line-of-cul.
Always shut off the laser light when you are
finished cutting.
Fig. 8
(
/_ CAUTION:
The Laser enhancing safety glasses that were included will
enhance the laser light in bright light conditions_. DO NOT wear these glasses if they
interfere with the safe operation of this saw.
LED WORKLIGHT (Fig. 9)
Your circular saw has a builtqn worklight for
better visibility when cutting. This light is
always "ON" when saw is plugged into power
source
19