Craftsman Professional 320.27311 Operator's Manual page 25

MAKING POCKET CUTS (Fig. 17)
,_ WARNING:
WARNING: ALWAYS adjust bevel setting to zero before making a
pocket cut, Attempting a pocket cut at any other setting can result in a loss of control
of the saw, which can result in serious injury,
! Adjust the bevel setting to zero, set the blade to the correct blade depth setting,
then use the lower blade guard lever to swing the guard up..
3
Z_ WARNING:
ALWAYS raise the lower blade guard with the lever to avoid /
serious injury-.
J
Fig. 17
2, While holding the lower blade guard up by the lever, firmly rest the front of the saw base
flat against the workpiece with the rear handle raised so the blade does not touch the
workpiece (see Fig t7)
3 Squeeze the trigger switch to start the saw. ALWAYS let the blade reach full speed, then
slowly lower the blade onto the workpiece until the base is flat against the workpieceo
AS the blade enters the material, you MUST release the lower blade guard lever.
4. After you complete the cut, release the trigger switch and allow the blade to come to a
complete stop. After the blade has stopped, remove it from the workpiece_ If the corners
of your pocket cut are not completely cut through, use a hand finishing saw to finish the corners
f }'k WARNING:
NEVER tie the lower blade guard in the raised position,,
Leaving the blade exposed could result in serious injury,
I
25