INSTALLING
A ND USING
THE EDGE GUIDE conto
6
Ptace the edge guide firmly
against the edge of the workpiece
(See Fig, t4a) Doing this will
give you a true cut without
pinching the blade.,
7, BE SURE that the guiding
edge of the workpiece is
straight so you can get
a straight cut.,
8, ALWAYS LETTHE BLADE
REACH FULL SPEED, then
carefully guide the saw into the
workpiece,, DO NOT bind the
blade in the cut. Push the
saw forward at a speed where
the blade is not laboring.
Fig, 14
Fig, 14a
HOWTO
SETYOUR
BEVEL
ANGLE
(Fig. 15)
. Unplug the saw,
Z_ WARNING:
ALWAYS unplug saw before making any adjustments.
Failure to
unplug the saw could result in accidental starting which can cause serious personal
inju_,
2. Loosen bevel adjustment lever (see Fig 15),
3 Raise the motor housing end of the saw
until you reach the desired angle setting
on the bevel scale.
4. Tighten the adjustment lever securely,
Fig, 15
Bevel
23