Tools Needed - Craftsman 113.226431 Owner's Manual

Clamping B elt
and Disc Sander
to Workbench .................................................... 7
Installing Sanding Disc and Guard ........................ 8
Installing Backstop ................................................. 8
Installing Table Assembly ...................................... 8
Auxilliary Mounting for Vertical Sanding .............. 10
Squaring Table Assembly .................................... 10
Installing the Sanding Belt - Tensioning
and Tracking .................................................... 10
unpacking
GETTING TO KNOW YOUR
BELT AND DISC SANDER....: .............................. 12
on-off Switch ....................................................... 13
BASIC OPERATION. ............................................... 14
Bevel Sanding ...................................................... 16
Positioning Belt Table ..... ........ ............................. 16
Surface Sanding on Sanding Belt ........................ 17
End Sanding on the Sanding Belt ............. ........... 17
Sanding Curved Edges ....................................... 17
Sanding Small End Surfaces ............................... !8
MAINTENANCE ...................................................... !9
Lubrication ........................................................... 19
Removing Pulley Cover and
Installing Timing Belt ....................................... 19
Installing Pulley Cover ......................................... 20
TROUBLESHOOTING ............................................. 21
RECOMMENDED ACCESSORIES ......................... 21
REPAIR PARTS ....................................................... 22
, L I Ill,
and checking contents
TOOLS NEEDED
10f, fM WRENCH
Pt||k LIPS IYP[ _
SCREWDRIVER
STAfJDARD
SCREWDRIVER
CC'MBIHA ,_$OH SQ [ JAf;,|_
gMM HEX "L" VV_I[14CIt
COMBINAI'ION SQUARE MUST BE TRUE
STRAIGHT EDGE OF BOARD
3/4" THICK_ THIS EDGE MUST
DRAW LIGHT LINE OH BE PERFECTLY STRAIGHT.
BOARD ALONG "rHtB EDGE *_'.,
SHOL_LD BE NO GAP OR OVENLAP
HERE WH]EN SQUARE IS FLIPPED
OVER EN DO*il'ED POSITION.
E T. N
N
Model 113.22643 Belt and Disc Sander is shipped
complete in one carton.
Separate all parts from packing materials and check
each item with illustration and 'q-able of Loose Parts."
NOTE: Make certain all items are accounted for, before
discarding any packing material.
WARNING: To avoid Injury, if any parts are misslng,
do not attempt to assemble the Belt and Disc Sander,
plug Inthe power cord, or turn the switch on until the
missing parts are obtained and installed correctly.
WARNING: For your own safety, never connect plug
to power source outlet, or Insert switch key until all
assembly steps are complete and until you have
read and understood the entire owners manual.
ITEM TABLE OF LOOSE PARTS QTY.
A Belt and Disc Sander Assembly 1
B Owner's Manual 1
C Table 1
D Sanding Disc 1
E Table Support 1
F Guard Disc 1
G Work Support 1
H Bag Assembly
Containing the following parts:
Knob 1
Washer, 6.5 x 17.8 x 1.6 5
Screw, Pan Hd. TY "AB"
M4.2 x 1.9-t 2 2
Switch Key t
Lockwasher, Ext. M6 4
Scale Label 1
Screw, Hex Hd. M6 x 1.0-14 4