Squaring Table Assembly - Craftsman 113.226431 Owner's Manual

AUXILIARY MOUNTING FOR VERTICAL
SANDING _
i i :
1_ Remove backstop lock boltand remove work support.
2. Removetabte assembly by removing table lock knob
and washer.
NOTE: Belt bed may be raised to vertical position by
loosening hex socket screw and raising bed. See
"Positioning Belt Bed" on page 16.
3. Attach table assembly to auxiliary holes in belt bed.
Make sureindex pin is in the upper hole when sanding
table is in the vertical position.
BACKSTOP REMOVED
SQUARING TABLE ASSEMBLY
WARNING: To avoid injury from accidental start,
make sure tool is unplugged before aligning.
1. Using a combination square, check the angle of the
worktable with the disc.
2,
NOTE: The combination square must be '1rue" - See
"Unpacking - Tools Needed" section on page 6 for
checking method.
if the table is not 90° with the disc, loosen table lock
knob screw and tilt table.
3. Adjust worktable square to the disc and retighten
table lock knob.
4. Attach scale label to 0° mark on dust guard.
/
SCALELABEL
TABLE LOCK
KNOB
COMBINATION
SQUARE
\
WORKTABLE
INSTALLING THE SANDING BELT -
TENSIONING AND TRACKING
WARNING: To avoid Injury from accidental start,
turn switch "OFF", remove key and remove plug
from power source outlet before removing orinstall-
Ing sanding belt. To avoid injury from belt failure,
use only Sears recommended sanding belts. See
Sears catalog.
On the smooth side of the sanding belt, you will find a
"directional arrow." The sanding belt must run in the
direction of this arrow so that the splice does not come
apart.
1. Slide tension lever to the right to release the belt
tension.
2. Place the sanding belt over the drums with the direc-
tional arrow pointing as shown. Make sure the belt is
centered on both drums.
BED LOCKING
HEX SOCKET
SCREW
TENSION
LEVER
D]RECT|ONAL
ARROW
IDLER
DRUM
J
10