Craftsman 113.226431 Owner's Manual page 11

3. Slide tension lever to the left to apply belt tension.
4. Tighten hex socket screw when bed is in desired
position.
5. Plug in the power cord. Turn switch "ON" and imme-
diately "OFF," noting if the belt tends to slide off the
idler drum or drive drum. If it did not tend to slide off,
it is TRACKING properly.
L ,LI ,=J1=,,i
"t'RACKIN G
}KNOB
6. if the sanding belt moves toward the disc, turn the _
tracking knob clockwise 114 turn.
7. If the sanding belt moves away from the disc, turn the __ _.F/_
tracking knob counterclockwise 1/4 turn.
8. Turn switch "ON" and immediately "OFF" again, not-
ing belt movement. Readjust tracking knob if neces-
sary.
11