Craftsman 113.226431 Owner's Manual page 16

knob.
WARNING: To avoid trapping the work or fingers
between the table and sanding surface, the table
should be reposlUoned on the table support to retain
a maximum of 1/16 inch distance between sanding
surface and table.
1! /
MAx., u,
sA.o'Noso" AoE
t! TABLE
, J
POSITIONING BELT BED
A bed lockinghex socket head screw locks the belt bed
in a vertical or horizontal position.
,WORK SUPPORT
3ELT BED
HEX SOCKET
SCREW
.HEX "L" WRENCH
1. Remove the work support.
2. Loosen the hex socket head locking screw using a
6ram hex wrench.
3, Position belt bed vedically as shown and tighten the
hex socket head screw.
HEX SOCKET
• SCREW
16