Table of Contents
Advertisement
FULL ONEYEAR
WARRANTY ON CRAFTSMAN BELT AND DISC SANDER
ifwithin one year from the date ofpurchase, this Craftsman BeItand Disc Sander fails due to a detect In material
or workmanship, Sears will repair it, free of charge.
WARRANTY SERVICE IS AVAILABLE BY SIMPLY CONTACTING THE NEAREST SEARS SERVICE CENTER/
DEPARTMENT THROUGHOUT THE UNITED STATES.
THIS WARRANTY APPLIES ONLY WHILE THIS PRODUCT IS USED IN THE UNITED STATES.
Thiswarranty gives you specific legal righta, and you may also haveother rightswhich vary from state to state.
SEARS, ROEBUCK
AND CO., D/817 WA Hoffman Estates, IL 60195
safety instructions for
Safety is a combination of common sense, staying alert
and knowing how yourbelt and disc sander works. Read
this manual to understand this sander.
BEFORE USING THE SANDER
WARNING:
TO avoid mistakes that could cause
serious, permanent injury, do not plug the sander in
until the following steps are completed.
belt and disc sander
WHEN INSTALLING
OR MOVING
THE
SANDER
AVOID DANGEROUS ENVIRONMENT.
Usethe sander
in a dry, indoor place protected from rain.
Keep work
area well lighted.
Place the sander so neither the user nor bystanders are
forced to stand in line with the abrasive belt or disc.
Assembly and alignment.
(See pages 7 - 11)
Learn the use and function of the ON-OFF switch,
backstop, belt tracking knob, belt tension lever, work
table andwork table titt lock knob. (Seepages 12-13)
Review and understanding
of all safety instructions
and operating procedures in this manual.
Review of the maintenance methods for this sander.
(See pages 19 - 20)
To avoid Injury from unexpected sander movement:
Always unplug the sander before moving it.
Putthe sander on a firm level surface where there is
plenty of room for handling and properly supporting
the workpiece
• Support the sander so it does not rock.
• Boltthe sanderto its work surface, Use the fasteners
and method shown in "Assembly and Alignment."
Readthe followingWARNING
abelfoundonthefrontof
(Page 7)
the sander:
•
NEVER STAND ON TOOL,
Serious injury could
occur if the tool tips. Do not store anything above or
ILWAR
,,l"'
ING
near the tool where anyone might stand on the tool to
GROUND THE SANDER.
This sander has an ap-
proved 3-conductor cord and a 3-prong grounding
type plug.
Use only 3-wire, grounded outlets rated
120 volts, 15 amperes (amps). The green conductor
in the cord is the grounding wire. To avoid electrocu-
tion, N EVER connect the green wire to a live terminal,
Make sure your fingers do not touch the plug's metal
prongs when plugging or unplugging the sander.
Hide quick links:
Advertisement
Table of Contents
