Door; Lift-Off Oven Door - GE JGSP28 Owner's Manual

GEAppliances.com
Donotruborcleon thedoor g asket-
it hasanextremety lowresistance to
abrasion.
ff you notice the gasket becoming worn.
frayed or damaged in any way or if it
has become displaced on the door, you
should haveit replaced
Cleaning the Oven Door
Toclean the inside of the door'.
# Becausethe area insidethe gasketis
cleanedduring the self-dean cycle,you
do not need to cleanthis by hand.
_ Thearea outsidethe gasket and
the door Iiner can be cleanedwith a
soap-filled or plasticscouringpad,
hot water and detergent.Rinse well with
a vinegarand water solution,
Toclean the outside of the doon
_;_ Usesoapand water to thoroughly clean
the top. sides and front of the ovendoor.
Rinsewelt.You may also usea glass
cleanerto cleonthe gloss
on the outside of the door. Donot let
water drip intothe vent openings,
if anystain on the door vent trim is
persistent,usea soft abrasivecleaner
and a sponge-scrubberfor best results.
_, Spillage of marinades,fruitjuices.
tomato saucesand bastingmaterials
containingacids may cause
discolorationand should bewiped
up immediately.When surfaceiscool,
clean and rinse.
_; Donot useovencleaners,cleaning
powdersor harshabrasiveson the
outside of the door.
Slot
c_p
Hinge lock
Putthingelocksdown to unlock.
Ram oval position
Lift-Off Oven Door
The door is very heavy. Be carefu! when
removing and lifting the door.
Do not lift the door by the handle.
Toremove the door:
%
[]
Fully open the door.
Pull the hinge locks down toward
the door frame, to the unlocked
position. A tool, such as a small
flat-blade screwdriver, may be
required.
Firmly grasp both sides of the door at
the top.
Close door to the door removal
position, which is halfway between
the broil stop position and fully closed.
[] Lift door up and out untiethe hinge
arm is clear of the slot.
To replace the door:
[] Firmly grasp both sides of the door at
the top.
[]
%
With the Bottom: 0
edge I Hin ie arm
door at the of slot _,\ !//t
same angle \
as the removal
position, seat the
indentation of
the hinge arm ::, ::
into the bottom
edge of the hinge slot. The notch in
the hinge arm must be fulty seated
into the bottom of the slot.
Fully open the door. If the door will
not fully open, the indentation is not
seated correctly in the bottom edge
of the slot.
[] Push the hinge locks up against the
front frame of the oven cavity to the
bcked position.
arm
Hinge lock _!//_"_" (_
Push hinge locks up to tack.
[] Closethe oven door.
25