Control Panel; Floor; Stainless Steelsurfaces; Vent - GE JGSP28 Owner's Manual

Care and cleaning of the range.
Stainless Steel Surfaces [onsome
models)
Do not use a steel wool pad; it will
scratch the surface.
To clean the stainless steel surface, use
warm sudsy water or a stainless steel
cleaner or polish, Always wipe the surface
in the dire_on of the grain. Follow the
cleaner instructions for cleaning the
stainless steel surface.
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer or P1abe Parts Store
nearest you, please cal_our toll-free
number,
National Parts Center£800.626,2002 (U.5.)
1.800.661.1616 tCanadaJ
GEAppliances,com _U,Sj
www.GEAppliances.ca fCanada!
Painted Surfaces
Paintedsurfacesincludethe top and sides
of the door,andthe drawerfront. Clean
thesewith soapand water or a vinegarand
water solution.
Donot usecommercial ovencleaners,
cleaningpowders,steelwool or harsh
abrasiveson any paintedsurface.
::!i:i_! i
Cooktop air inlet
Oven Vent and Cooktop Air Inlet
The oven is vented through an opening in
the cooktop under the grille, The cooktop
takes in air through the air inlet located
through the cooktap.
Never cover these openings with
aluminum foil or any other material. This
would prevent the vents from working
properly.
Control Panel
If desired, the touch pads may be turned off
before cleaning.
Seethe Control Lockout section,
Clean up splatters with a damp cloth.
Remove heavier soil with warm soapy
water. Do not use abrasives of any kind.
Turn on the touch pads after cleaning.
Removable Oven Floor
!! :__ To remove the oven floor for easier
cleaning:
[_ Remove the oven door using the
instructions in the Lift-Off Oven Door
section.
..... .... ..... : [_ Grasp oven floor at the rear finger
slots on each side, lift it up, push it
back and puli it out.
D[] Clean the oven floor with warm soapy
water.
IMPORTANT:Always replace the
removable floor before the next use.
26