Oven Door - GE JBS62 Owner's Manual

Interior Surfaces
Porcelain Oven Interior
With proper care, the porcelain enamel finish on the
inside of the oven - top, bottom, sides, back and inside
of the door - will stay new-looking for years. Let the
oven cool before cleaning. We recommend that you
wear rubber gloves when cleaning the oven. Soap
and water will normally do the job. Heavy spattering
or spillovers may require cleaning with a mild abrasive
cleaner. Soap-filled scouring pads may also be used.
Do not allow food spills with a high sugar or acid content
(such as tomatoes, sauerkraut, fruit juices or pie filling)
to remain on the surface. They may cause a dull spot
even after cleaning. Household ammonia may make the
pottery container in a cold oven overnight. The ammonia
necessary, you may use an oven cleaner that is certified
for use in a self-cleaning oven. Follow the package
directions.

Oven Door

WARNING
appendages near the hinge. Follow instructions below to avoid a risk of injury when removing and
re-installing the oven door.
To Remove the Door:
1. Fully open the oven door.
2. On each hinge, slide the hinge lock up, making sure it
snaps into its fully raised position.
3. Firmly grasp both sides of the door at near the top.
4. Close door until the top of the door is approximately
5. Lift door up and away from the range until both hinge
arms are clear of the slots in the range frame.
To Replace the Door:
1. Firmly grasp both sides of the door near the top.
2. With the door at the same angle as the removal
position, rest the notch in the bottom of the left hinge
arm on the bottom edge of the left hinge slot. The
notch in the hinge arm must be fully seated onto the
bottom of the slot. Repeat for the right side.
the notches in the bottoms of the hinge arms are not
seated correctly onto the bottom edge of the slot. Lift
the door off the range and repeat Step 2.
4. Push the hinge locks down to the locked position
5. Close the oven door.
18
• Do not spray oven cleaner on the electrical controls
and switches because it could cause a short circuit
and result in sparking or fire.
• Do not allow a film from the cleaner to build up on
the temperature sensor - it could cause the oven to
heat improperly. (The sensor is located at the top of
the oven.) Carefully wipe the sensor clean after each
oven cleaning, being careful not to move the sensor
as a change in its position could affect how the oven
bakes.
• Do not spray any oven cleaner on the oven door,
handles or any exterior surface of the oven, cabinets
or painted surfaces. The cleaner can damage these
surfaces.
Pull hinge locks up to unlock
Notch
Removal position
Push hinge locks down to lock
49-2001599 Rev. 0