GE JGSP28 Owner's Manual page 30

Before you call for service...
Troubleshooting Tips
Possible Causes What To Do
The installed connection • Contact instalter or electrician to correct miswire.
from the house to the unit
is miswired.
You forgot to enter a - Touch the BAKE pod and desired temperature or
bake temperature or the SELF CLEAN pad and desired ctean time.
cleaning time.
ii _!_ii_i_n_: !ii!:(iii:i:iiii! A fuse in your home may • Replace the fuse or reset the circuit breaker.
ii!!!i! ! i:ii! i il bebreakerbl°Wntripped.°r
the circuit
iiii:i !iiiii!iiii!iiiii 'i : :i!i iiilil : TheclOCkblock_out iSmode.in , See the Using the dock and timer section.
Power failure. • Reset the clock.
Oven control pads were • The BROIL .l/LO and BAKE pads must be touched at
not touched properly, the same time and held for 3 seconds
Power outage or surge. • Reset the clock. If the oven was in use, you must reset
it by touching the CLEAR/OFF pod, setting the cbck
and resetting any cooking function.
This is normal in a new oven • To speed the process, set a self-dean cycle for a
and will disappear in time. minimum of 3 hours. See the Using the self-cleaning
oven section,
An odor from the insulation • This is temporary
around the inside of the oven
is normal for the first few
times the oven is used.
A coolingfan may
:::::::::::::::::::::::::::: a utomatically turn
on and off.
• This is normal. The cooling fan will turn off and on
to cool internal parts. It may run after the oven is
turned OFF.
3O