Advertisement
TO ATTACH
BATTERY
PACK TO DRILL
See Figure 5.
Note: Battery pack is shipped in a low charge condition.
Therefore, it must be charged prior to use. Refer to page 10,
"CHARGING BATTERY PACK" for charging instructions.
•
Lock the switch trigger by placing the direction of
rotation selector in center position. See Figure 10.
•
Align raised ribs on battery pack with grooves on
bottom of drill, then attach battery pack to drill as
shown in Figure 5.
•
Make sure latch on battery pack snaps in place and
battery pack is secured to drill before beginning
operation.
TO REMOVE
BATTERY
PACK
FROM DRILL
See Figure 6.
•
Lock the switch trigger by placing the direction of
rotation selector in center position. See Figure 10.
•
Depress latch located on front of battery pack (1) to
release battery pack.
•
Pull forward on battery pack (2) to remove from drill.
DEPRESS LATCHTO
RELEASEBATTERYPACK
LATCH
RAISEDRIBS
PULL
FORWARD
TO REMOVE
GROOVES
BATTERYPACK
Fig. 6
BAI-rERYPACK
Fig. 5
_1
CAUTION"
When attaching battery pack to your
drill, be sure raised ribs and grooves align properly
and latch snaps in place properly. Improper assembly
can cause damage to drill and battery pack.
Advertisement
