Vac Assembly - Craftsman 113.170160 Owner's Manual

Vac Assembly
1. Locate the power assembly and the
drum assemblies (assembled earlier).
2. Position the power assembly with the
inlet of the unit located in line with the
drain cap and the drum label on the
vac. Allow the assembly to rest on the
vac drum.
3. Rotate both latches down until you hear
the latches snap over the lip of the
drum.
Latch
atch
NOTE: For best appearance of the unit,
the inlet of the vac should be located
above the drain.
Inlet
Drum
•Drain
4. Insert the push button end of the hose
assembly into the inlet of the vac. The
hose should snap into place. To remove
the hose from the vac press the release
button in the hose assembly and pull
the hose out of the vac inlet.
5. Place the utility nozzle securely on the
swivel end of the hose and the vac is
ready for use.
\
Release
Button
Press and
Pull
7