Filter Assembly; Caster/Caster Foot Assembly - Craftsman 113.170160 Owner's Manual

16 gallon convertible wet/dry vac
Table of Contents

Advertisement

Filter Assembly
1. Locate the filter, filter plate and filter
nut.
2. Carefully slide the filter over the filter
cage, sliding it over the center ring cov-
ering the 3 notched areas until the filter
stops against the lid.
3. Place the hole in the filter plate over
threaded screw of the filter cage.
4. Gently push on the filter plate to seat
the rubber ring of the filter inside the cir-
cular channel of the filter plate.
5. Place filter nut onto threadecl screw and
tighten it down. Finger tighten only.
NOTE:
Lever of filter nut should be away
from plate as shown.
iMPORTANT:
Do not overtighten as this
may deform or crack the filter plate, filter
cage or the filter.
NOTE: Your filter has a red stripe that
matches an in-store displayer. When you
visit your local Sears store, just remember
the color of your stripe for the correct size
filter.
Screw
,_
""-Filter
Nut
"_--Filter
Plate
_FRI_r
Stdpe
Power
Filter
Cage
Caster/Caster
Foot Assembly
1. Remove the power assembly from the
dust drum and set aside.
2.Turn the dust drum upside down on the
floor.
3. Insert the caster feet into the bottom of
drum, as shown (4 places).
4. Push on the caster foot until the foot
rests against the first step of the dust
drum.
5. Insert the caster stem into the socket of
the caster foot, as shown (4 places).
6. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will hear the ball snap
into the socket and the caster will swivel
easily when positioning is correct.
7. Turn the drum upright.
_._
Caster
Stem
I st Step --,.-
Dust Drum

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents