Vac Assembly; Insert Hose; Accessory Storage - Craftsman 113.179715 Owner's Manual

Assembly (continued)
Vac Assembly
1. Line up front (label and switch side) of
power assembly with drain cap and Vac
port located on the front of the drum.
Note: Power assembly must be aligned
with drum for proper attachment.
2. Place power assembly on top of drum.
3. Be sure power assembly completely
covers the top of the drum so leakage
does not occur.
4. Upon releasing flexible latches, the
power assembly will attach to the drum.
5. To remove the power assembly, lift up
on the flexible latches and remove from
drum.
Power
Accessory Storage
Your accessories may be stored in the
accessory storage bag, or in the two
locations on the power head assembly.
Accessories
Storage
Location
-- OR --
Wand
Storage
Bag
Flexible
Latch
Vacuum Drain
Port
Insert Hose
Insert the hose locking end of the "Pos-I-
Lock®" Premium hose into the inlet of the
Vac. The hose should snap into place. To
remove the hose from the Vac, press the
release button in the hose assembly and
pull the hose out of the Vac inlet, as
shown.
The hose may be stored by wrapping it
around the unit and plugging the open
end into one of the storage locations on
the caster feet or in the storage bag.
Open End
Of Hose
Hose
Button
End Of Hose
-- OR --
j Hose Storage
Y
Storage
Bag