Table of Contents
Advertisement
_
WAF{NING: D onotallowfamiliarity withtoolsto
makeyoucareless. Remember thata careless
fractionofa second issufficient t o inflictserious
injury.
_
WARNING:Always wearsafetygoggles or safety
glasses withsideshbldswhenoperating tools.
Failure to doso couldresult i nobjectsbeingthrown
intoyoureyes,resulting inpossible serious injury.
WAF{NiNG: D onotuseanyattachments or acces-
sories not recommended bythe manufacturer of
thistool.Theuseofattachments o raccessories n ot
recommended canresult i nserious personal injury.
APPLICATIONS
You may use this tool for the following purposes:
[] Ddliing in wood
[] Drilling in ceramics, plastics, fiberglass, and laminates
[] Drilling in both hard and soft metals
[] Using driving accessories, such as driving screws with
screwdriver bits
CAUTION:
To prevent damage to the battery pack,
remove the battery pack from the charger immedi-
ately if no LED comes on. Return the battery pack
and charger to your nearest service center for check-
ing or replacing. Also, if you are removing the battery
pack from the charger and no LEDs are on, return
both the battery pack and the charger to your near-
est service center. Do not insert another battery pack
into the charger. A damaged charger may
damage a battery pack.
LED FUNCTIONS
OF CHARGER
LED WiLL BE ON TO iNDiCATE
STATUS OF
CHARGER
AND BATTERY
PACK:
[] Red LED on = Fast charging mode.
[] Green LED on = Fully charged and in maintenance
charge mode.
[] Green LED on = When battery pack is inserted into
charger, indicates hot battery pack or that battery pack
is out of normal temperature
range.
[] Yellow and Green LEDs on = Deeply discharged or
defective battery pack.
[] No LED on = Defective charger or battery pack.
CHARGING
THE BATTERY
PACK
Battery packs for this tool are shipped in a low charge
condition to prevent possible problems. Therefore, you
should charge it until the green LED on the front of the
charger comes on.
NOTE: Batteries will not reach full charge the first time
they are charged. AI!ow several cycles (operation fol!owed
by recharging) for them to become fully charged.
CHARGmNG A COOL BATTERY
PACK
If battery pack is below normal temperature
range, the
green LED on charger wit! come on. Allow battery pack to
reach normal temperature, then the red LED wil! come on.
NOTE: If the charger does not charge the battery pack
under normal circumstances,
return both the batten/pack
and charger to your nearest Sears Repair Center for
electrical check.
[] Charge the battery pack only with the charger provided.
[] Make sure the power supply is normal household
voltage, 120 volts, 60 Hz, AO only.
[] Connect the charger to the power supply.
[] Place the battery pack in the charger aligning raised rib
on the battery pack with the groove in the charger.
See Figure 2.
[] Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
[] Normally the red LED on charger win come on. This
indicates the charger is in fast charging mode.
CHARGER
_
GREENLED
_
YELLOWLED
I
AUTmON
Do not use any DC to AC power
inve_ters, Charger
wimm be Damaged!
Fig. 2
11
Advertisement
Table of Contents
