Fisher & Paykel DishDrawer DD605 User Manual page 32

IIFa u liltcod es
How to recognize a fault code
When a fault has occurred the DishDrawerC' w ill continuously beep every second,
ll!!!!iiii i!!ii ¸
The fault code will be displayed on the electronic display for prefinished models and on the
wash program selector for integrated models.
Each fault code is shown in the "Following chart for prefinished and integrated modeJs_
How to atte_d to a fault code
1 Press the O button to remove the fault code.
2 If the fault code and continuous beeps cannot be removed by pressing the O button, turn the
DishDrawer ° off at the power supply.
:5 We recommend you check the following chart and correct the fault where possible.
4 After attending to the fault, turn the DishDrawed' on at the power supply.
5 If the fault code and continuous beeps remain, turn the water and power supply off to the
DishDrawed'
When ca[ling your Authorized Service Center advise them of the fault code that has appeared
on the DishDrawer% This information will help the Authorized Service Center respond to your
request.