Fisher & Paykel DishDrawer DD605 User Manual page 21

Watelr softenelr
(©S605=H,
©©605=H models oMy}
Setting up the water softener
Using hard water (above 100ppm) for dishwashing can be detrimental to the performance of
your DishDrawer< Glasses will become opaque and dishes will become spotted or covered in a
white film,
Determine the water hardness in your _oca[ area
Yeur local water company wiJl be able to provide you with information, identify the setting you
require for your DishDrawe¢' from the water hardness table below. For example, if your water
hardness is 500ppm, then the water softener setting on your DishDrawep' should be fouc Refer
to Option Adjustments section to adjust the water softener so that the setting corresponds to
0
1
2
3
4
5
0-6
614
1420
2026
26-32
32-36
0-100
100-250
250-350
350-450
450-550
550-625
Note:
If },,our water hardness is above 625ppm, we highly recommend you completely fill the
detergent compartment for all programs except Rinse and the rinse agent setting be at 5. If your
water hardness is above 625ppm, the performance of your DishDrawer ° will decline,
You may hear some unusual noises when the water softener is in operation, this is normal
How to fill the salt reservoir
Open the DishDrawer<
Unscrew the salt reservoir plug by turning counter
clockwise
Place the salt into the salt container and pour the
contents into the sal'r reservoir The salt reservoir
can hold just over one pound/O 5 kg of salt
Fit the cap tightly back into its original position
If you do not wash your dishes immediately after filling
the salt reservoir, run a rinse program to remove any salt
water or spilt granules.
Note:
When filling the salt dispenser, you may notce water
being displaced from the water softener
overflow.
\