Fisher & Paykel DishDrawer DD605 User Manual page 31

Continuous
beeping
intermittent
beeping
DishDrawer"' will
notstart
Excess water inthe
D[shDrawe¢ _
Water marks on the
dishes
A fault has occurred, Refer to the Fault codes section.
DishDrawer ' is in pause Close the DishDrawer ' and press the _t'jj
mode. button.
Power supply is not Connect the power supply.
connected
The drawer is not closed Ensure the drawer is firmly closed.
properly.
Lock feature is on. Turn Lock off Hold down the _/@/@
button until the@/_symbol disappears from
the LCD screen or the light above thee/@
/_ button disappears.
I_!lJ button not pressed. Press the _iH button.
Drain hose(s) bent or Straighten the drain hose(s).
kinked.
Blocked filters. Clean the filter plate/drain filter. Refer to the
'User maintenance instructions' section.
Rinse agent depleted Refill the rinse agent dispenser
Rinse agent setting too low. Increase the rinse agent setting
DishDrawe¢' overloaded/ Refer to the section on loading
incorrectly loaded
Insufficient or no salt in the Ensure there is enough salt in the water
water softener (DD605H or softener and/or increase the water
DS605H). softener setting.
DishDrawe¢ " Some foods, like tomato Pre--rinse dishes before placing in the
interior is stained based products, may DishDrawe¢' Alternatively, using the Rinse
stain the inside of the program after adding the dishes may
DishDrawe¢'. minimize staining.
Dishes did not dry Incorrect loading Ensure the dishes are not nesting together.
Rinse agent depleted Refill the rinse agent dispenser
Rinse agent setting too low Increase the rinse agent setting
Eco wash program used Choose a standard wash program.
No detergent Detergent dispenser was Clean the dispenser and ensure the
dispensed wet when loaded, dispenser is dr}, when adding detergent
Excessive motor The filter plate and/or spray Refer to the'User rnaintenance instructions'
noise arm is incorrectly placed, section for details on correct placement.
No water in the motor area. This usually occurs on the first use or when
the DishDrawed' has not been used for
long periods of time Run the DishDrawed'
through a wash program.