Electric Brake - Craftsman NEXTEC 320.30565 Operator's Manual

VARIABLE SPEED (Fig.3)
The variable-speed trigger switch delivers higher speed with increased trigger
pressure and lower speed with decreased trigger pressure.
DIRECTION-OF-ROTATION SELECTOR (FORWARD/CENTER LOCK/
REVERSE) (Fig. 3)
The direction of bit rotation is reversible and is controlled by a selector located
above the trigger switch.
With the drill/driver held in normal operating position:
1. Position the direction-of-rotation selector to the left of the tool for drilling.
2. Position the direction-of-rotation selector to the right of the tool for reverse.
3. Setting the switch in the OFF (center lock) position helps reduce the possi-
bility of accidental starting when not in use.
_, CAUTION:To prevent gear damage, always allow the chuck to come to a
complete stop before changing the direction of rotation.
NOTICE: The drill/driver will not run unless the direction-of-rotation selector is
engaged fully to the left or right.
ELECTRIC BRAKE
To stop the drill/driver, release the trigger switch and allow the chuck to come to
a complete stop. The electric brake quickly stops the chuck from rotating. This
feature engages automatically when you release the trigger switch.
KEYLESS CHUCK (Fig. 4)
The drill/driver has a keyless
chuck to tighten or release bits
in the chuck jaws. The arrows
on the chuck indicate the direc-
tion in which to rotate the chuck
body in order to GRIP (tighten)
or OPEN (release) the chuck
jaws on the bit.
_, WARNING: Do not hold the
chuck with one hand and use
the power of the drill/driver to
tighten the chuck jaws on the drill
bit. The chuck body could slip in
your hand, or your hand could
slip and come in contact with the
Fig. 4
Keyless chuck
UNLOCK
Chuck jaws (release)
LOCK (tighten)
Chuck
rotating bit. This could cause an accident resulting in serious personal injury.
30565 ManuaLRevised_11-0616 Page 15