Craftsman NEXTEC 320.30565 Operator's Manual page 8

Do not place the drill/driver or battery pack near fire or heat. They
may explode.
Use only the recommended the battery pack 320.11221 and charger
320.29497, 320.14300, 320.10006. Any attempt to use another battery pack
will cause damage to the drill/driver; it could possibly explode or cause a fire
or personal injury.
Use auxiliary handle(s), if supplied with the tool. Loss of control can cause
personal injury.
Secure the workpiece. Clamping devices or a vise will hold the workpiece in
place better than the hand.
Always wait until the machine has come to a complete stop before placing it
down. The tool insert can jam and lead to loss of control over the power tool.
Before performing any kind of work on the tool ( e. g. maintenance, bit
change, etc.) or when transporting and storing it, always set the rotational
direction switch to center off position. Unintentional activation of the On/Off
switch may result in personal injury.
Use protective gloves when removing the bit from the tool, or first allow the
clamp to cool down. The bit may be hot after prolonged use.
Do not dispose of a worn out battery pack by incinerating. Do not incinerate
the battery, even if it is severely damaged or completely worn out. The
battery may explode in fire.
Do not operate the drill/driver or the charger near flammable liquids or in a
gaseous or explosive environment. Internal sparks may ignite fumes.
To reduce the risk of electric shock, do not put the drill/driver, battery, or
charger in water or other liquid. Do not place or store the product where it
can fall or be pulled into a tub or sink.
Do not store the drill/driver in a damp or wet location. Do not store in
locations where temperature is less than 32°F (0°C) or more than 104°F
(40°C). Do not store outside or in vehicles.
Do not permit children to use the drill/driver; it is not a toy.
The drill/driver worklight lens may produce sufficient heat to melt some
fabrics. To avoid serious personal injury, keep the Drill worklight free from
contact with other items.
Keep the drill/driver dry, clean and free from oil and grease. Always use a
clean cloth when cleaning. Never use brake fluids, gasoline, petroleum-
based products, or any strong solvent to clean the drill/driver.
Do not expose the drill/driver to rain or wet conditions. Water entering the
tool will increase the risk of electric shock.
30565 ManuaLRevised_11-0616 Page 8