Electric Brake - Craftsman evolv 320.30854 Operator's Manual

TO DETACH BATTERY PACK (Fig. 3}
1. Lock the trigger switch on the drill/driver by placing the direction-of-rotation
(forward/center-lock/reverse) selector in center position.
2. Depress the battery release buttons located on the front of the battery pack
to release the battery pack.
3. Pull forward on the battery pack to remove it from the tool.
_, WARNING: Battery tools are always in operating condition. Therefore, the
direction-of-rotation selector should always be locked when not in use or when
carrying the tool at your side.
TRIGGER SWITCH (Fig .4}
To turn the drill/driver ON, depress
the trigger switch. To turn it OFF,
release the trigger switch.
VARIABLE SPEED (Fig. 4}
The variable-speed trigger
switch delivers higher speed
with increased trigger pressure
and lower speed with decreased
trigger pressure.
Fig. 4
Forward
Variable-
speed trigger
switch
Reverse
Direction-
of-rotation
selector
DIRECTION-OF-ROTATION
SELECTOR (FORWARD/
CENTER-LOCK/REVERSE)
(Fig. 4)
The direction of bit rotation is reversible and is controlled by a selector located
above the trigger switch. With the drill/driver held in normal operating position:
Position the direction-of-rotation selector to the right of the tool for
forward rotation.
1.
2.
4.
Position the direction-of-rotation selector to the left of the tool for reverse rotation.
Setting the switch in the OFF (center-lock) position helps to reduce the
possibility of accidental starting when not in use.
NOTICE: To prevent gear damage, always allow the drill/driver to come to a
complete stop before changing the direction of rotation.
NOTICE: The drill/driver will not run unless the direction-of-rotation selector is
engaged fully to the left or right.
ELECTRIC BRAKE
To stop the drill/driver, release the trigger switch and allow the tool to come to
a complete stop. The electric brake quickly stops the bit rotation. This feature
engages automatically when you release the trigger switch.
30854 Manual Revised 11-0616 Page 15