Owner's Manual Manual del Usuario I1!'1 I CRRFTS.R. ! HEIGHT ADJUSTABLE CLAMPING TABLE BANCO DE TRABAJO DE FIJACION R/_PIDA Model No. 695.65796 Modelo N-°695.65796 CAUTION: Before using thls product, read this manual and follow all its Safety Rules and Operating Instructions.
When operating a portabte power tool such as a drill, router_ sander or planer: CRAFTSMAN _ Height Adjustable Clamping Tdble until you have read the safety instructions tnthis section. Always be sure that the workplace Is securely ¢le_'nped to your Clamping Table, This will avoid kickback which Safety Items throughout this manual are labeled with could cause serious bodily injury.
PACKAGE CONTENTS Separate ell parts'from packaging materials and check each Item with Figure 1 and "Table of Loose Parts." Your CRAFTSMAN ° Clamping Table is shipped Make sure a!l items are accounted for before dlscardlng complete in onecarton, any of the packing material.
CRAFTSMAN e Clamplng Table provides a work toofs, surface of up to 40-3/4 '_.It features a largo 30" x 20-1/2" screwdrivers and chisels. Jaw Is adjustable up to 9 ti(ting top made of durable _B/4-1nch thlak MDF (Medium degrees for holding Irregularly-shaped workpleoes.
Solid Surface Table 1o With one foot on step bar, slowly loosen one height adjustment locking handle. Then slowly loosen the Your CRAFTSMAN e Clamping Table can be used as a other handle°(See Figure 4,) Solid Surface Table (Figure 5) and as a Cl_mplng With table top resting on thigh, carefully lower or Table,.
The swivel pegs can be posltloned into any of the holes Jaw Use and Adjustment In theJaws and rear of top for gripping frregular shaped Your CRAFTSMAN ® Clamping Table ls designed for workpleces, or to extend gripping and clamping when maximum versatility.The Tabte top jaws adjust to clamp your workplaceexceeds _hajaw capacity, (see F3gure 8.)
Swlve! pegs used Close table top Jaws until narrow enough grip workplace only In cases where the workplace, Place workpleoe In vertloal groove in workplace DOLES NOT extend beyond the surface of the peg support and tighter table top jaws until Jaws.
Carrying the Clamping Table Figure 14 With the Clamping Table folded end clamping table o!osed, carefully !Ift the Olamplng Tabre by the yellow support grip mounted to the tool storage rack. (See Figure !3.) To avoid havlng the shop stand open while moving, make aura handles are tightenedsecurely.
Unpacking and Checking Model No. 695.65796 _-FF ?_AA...
Contents Part Set PART NO. DESCRIPTION 119 800 364 Board - Front, Drilled and Printed ..........1 I17 900 042 Board - Front, Raw Matedal ............ 1 119 800 385 Board - Rear, Ddlted and Printed ..........1 117 900 04.3 Board - Rear, Raw Materlal ............