Advertisement
The
CRAFTSMAN e Clamplng Table provides a work
surface of up to 40-3/4 '_.It features a largo 30" x 20-1/2"
ti(ting top made of durable _B/4-1nch thlak MDF (Medium
Denslty Fiber). Its steel frame supports up to 330 Ibs,,
and thero ]s a convenient storage rack with slots for
table pegs, parts and for hand
toofs,
such as
screwdrivers and chisels. Jaw Is adjustable up to 9
degrees for holding Irregularly-shaped workpleoes.
A step bar provldes additional support and stability,
The major
components
of your dRAFTSMAN
®
Clamping Table have been assembled at 1he factory.
This lnctudes the table top, the support posts, and tho
legs, You need to complete _he shop stand by assem-
bling the following components to each other."
=
table top to support posts
=
short locking handles to support posts
=
feet to Iegs
•
long locking handles to Ieg_
=
table top/support posts to logs
For these
proaedures,
you
need a #3 Phillips
screwdriver
and an adjustable-head
wrench.
Table Top to Support Posts
1.
Place stand top (A) upside.down
on a smooth
surface. (See Ftgura 2,)
Figure 2
2.
With vlangular-shapod tilt brackets on Inside of rail
and pivoted toward rear of table, attach _upport
posts assembly (D) with 4 bolts (H) and 4 nuts (N),
2 on each side,
3.
Tighten with Phillips screwdriver
and adjustable-
head wrench.
Looklng Handles to Support Posts
1,
Move support
posts assembly
(D) to most
advanced position (small tabs Ilmlt movement).
(See Figure 2.)
2.
Maintaining a_embly
In most advanced posltlon
with your shoulder, place tabs of nut holder (F)
(over nut [I_]) and Into slots. White holding nut
holder In slot with nut, use other hand to thread
short looking handle (B) Into nut
3.
Repeat for other side.
To tighten: Turn handles clockwise.
To loosen: Turn handles counterclockwise.
B
D
N
F
D
F
H
A
4
Advertisement
