Advertisement
Figure 5
Adjusting Jaw to Angle
Front Jaw adjusts to a maximum angle of 9 degrees for
olamplng Irregular shaped workplsces. To adjust jaw to
angle, turn either the right or left adjustment handle until
desired angle is reached. (See Figure 7.)
Figure 7
Jaw Use and Adjustment
Your CRAFTSMAN ® Clamping Table ls designed for
maximum versatility.The Tabte top jaws adjust to clamp
many workplace sizes or shapes to simplify sawing,
planing, sanding, drilling, routing, gluing and painting
jobs,
Fi_lure
6
DO NOT attempt to use your Olamping
Table unless the Jaws are securely
locked in position,
To Adjust
Table
Top Jaw
Turn the 2 front table top jaw adjustment handles
counterotockwiseto move front jaw out; turn adjustment
handles clockwise to move front Jaw In_(See Figure 6.)
The table top Jaw opens to clamp a maximum 4-1nob
wide workpfece.
Using
Adjustable
Swivel
Pegs to Hold
Irregular
Shaped
Workpieoes
Your Olamplng Table Is equipped with 4 swivel pegs.
The swivel pegs can be posltloned into any of the holes
In theJaws and rear of top for gripping frregular shaped
workpleces, or to extend gripping and clamping when
your workplaceexceeds _hajaw capacity, (see F3gure 8.)
1.
Fully extend fmntJaw.
2.
Place workplace on stand top.
3.
Push sw]ve] pegs into appropr]ate holes tn table top
and tighten jaw to securely grip workplace. (See
Figure8.)
Figure 8
Increasing
Gripping
and Clamping
Capacity
If workplaceexceedsJaw capacity,reposltlonswivel pegs
Into hole Inthe back row of holes tn tabletop.(See Rgure9.)
Advertisement
