Download Print this page

Craftsman 695.65796 Owner's Manual page 2

Height adjustable clamping table
Hide thumbs

Advertisement

WARRANTY ...............................................................
2:
SAFETY INSTRUCTION8 .........................................
8
INTRODUCTION ........................................................
4
ASSEMBLY ................................................................
4
Full One Year Warranty
OPERATION ..............................................................
5
_PE(31FI{3AT[O_J_ .....................................................
8
UN-PACKING AND CHECKING ........................... ,..... 9
ESPAI_IOL ................................................................
11
If this ORAFTSMAN _ Olamplng Table fails to give
complete satisfaction wlthtn one year from the date
of purchase, return It to (or contact) the nearest
8ears Service Center In the United States, and
Sears wilt repair It, free of charge.
This warranty gives you specific legal rights and you
may also have other rights which vary from state to
state.
Sear=, Roebuck and Co.,
D/817WA_ Hoffman Estates, IL 60179
DO NOT attempt
to assemble
or operate
your
CRAFTSMAN _ Height Adjustable Clamping Tdble until
you have read the safety instructions tnthis section.
Safety Items throughout this manual are labeled with
WARNING or CAUTION,
Means
that faltura
to fot!ow
this
safety
statement
may
result
tn
extanelvs p roduct damage, serious personal Injury or
death.
Means
that failure
to fellow
thls
safety statement may result In mtnor or
moderate
personal In]ury, property
or equipment
damage.
DO
NOT
use
this
too[
for
scaffolding or as a ladder, Make sure to
fully tighten handles when in use. Maxlmum capacity
380 Ibs,
Read all Instructions.
@ DO NOT load clamplng table with more than SSo lbs.
@ DO NOT apply an unbalanced load which could
result tn the shop stand tipping over.
DO NOT attempt to use your portable
workbench unless the Jaw Is securely
looked in position.
When operating a stationary power tool
such as a Mitre Saw, on your Olamplng
Table, be sure the tool is securely bolted to a separate
piece of plywood and the plywood Is securely clamped
to the work table. DO NOT clamp or mount stationary
power tool directly to table top, This could cause serious
bodily damage.
When operating a portabte power tool
such as a drill, router_ sander or planer:
Always be sure that the workplace Is securely ¢le_'nped
to your Clamping Table, This will avoid kickback which
could cause serious bodily injury.
'
1"o prevent
persona[
Injury
while
opening or closing your workbench,
always avoid positioning hands or fingers where they
couldget pinched,
®
DO NOT stand or climb on the shop stand. It could
fall or_p over causing serious Injury,
®
Be sure the shop stsnd's leg set frame assembly Is
in the fuliy opened position before using.
®
Dress for safety. DO NOT wear loose clothing,
gloves, necktles or Jewelry (rings, watches); they
can get caught and draw you Into moving parts_
ALWAYS wear non-aIlp footwear; tie back hair.
@
@
DO NOT store a_hopstand outdoors or
{n a damp location,
ALWAYS keep your work area clean, uncluttered
and well lit. DO NOT work o.n or place shop stand
legs on floor surfaces theft are slrppery
from
sawdust, oil, water or wax
Keep visitors or ohlldren a sadie distance away from
the work area, especially when you're operating a
power tool, Visitors should wear the same safety
equipment as the operator,
@
SAVE THESE INSTRUCTIONS.
2

Advertisement

loading