Advertisement
Figure
3
h
Feet
to Legs
Attach 2 feet
(G) to :he front
legs
and 2 feet (M) to the
back legs, (See Figure
3,)
Locking
Handles
to Legs
- Figure
3
Two handles allow you to qulckly and esstly adjust the
height of your stand.
1.
Futiy open legs and place on floor.
2.
Thread long Jooktng handle (L) into welded nut on
each Ieg_
Table
Top/Support
Posts
to Legs
- Figure
3
1.
Height adjust looPJng handles
should
be threaded
only slightly at thls time.
2.
Lightly lubricate support posts (O) and carefully pick
up labia top (A) and posts. With foot on step bar for
stability, securely Insert posts Into legs (C)o if support
posts (D) make
a scratching
notes then lightly
lubricate.
3o
Place table top at desired height and lighten height
adjust rooking handles.
Turn handles olookwise to
tighten; turn handles oounterclootcwlee to loosen,
This
Clamping
Table
DOE8
NOT
provide adequate
support for any table
top tools that weigh tn excess of 90 Ibs. or that exceeds
an overall combined
height with table over 60 Inches,
Using any tools in excess of these
weight and height
measurements
could result In sedous injury.
When operating
a stationary
power
tool
euoh
as a mitre
e_w,
on your
clamping
table, be aura the tool ts securely
bolted to a
separate
pleoe of ptywood
and that the plywood
Is
securely
elarnped
to the Clamping
Table.
DO NOT
clamp
or mount stationary
power toot directly to table
top. This could cause serious bodily damage,
When operating
a portable power _ooI
such
as
a drill,
router,
sander
or
planer:
Always
bs sure
that
the workpiece
Is securely
clamped
to your
Cramping
Table,
This
will
avoid
kickback
whloh
could cause
serious
bodily
Injury.
Ad
|ng
Height
To avoid
Injury,
remove
tools and
parts
from
top
before
adjusting
Clamping Table height.
1o With one foot on step bar, slowly loosen one height
adjustment
locking handle. Then slowly loosen the
other handle°(See Figure 4,)
2_
With table top resting on thigh, carefully lower or
heighten tabletop.
3.
With table top still resting on thlgh, reach down and
secure one height adjustment looking handle., Then
secure the otherIooklng handle.
Figure
4
HEIGHT
ADJUSTMENT
LOCKING
HANDL_
Solid
Surface
Table
Your CRAFTSMAN
e Clamping Table can be used as a
Solid Surface
Table
(Figure
5) and as a Cl_mplng
Table,. To convert from solid surface
to olamptng table
simply remove the solid surface center board and adjust
table top Jaws for desired application.
Refer to Figures
6, 7, 8, 9, 10 and 11.
Advertisement
