Usingthe Wok Stand - Electrolux EW30GC55GB1 Use & Care Manual

Surface Cooking
USINGTHE WOK STAND (ACCESSORY NOT H NCLUDED)
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
The Wok Stand is designed to allow round-bottomed woks to be used. it is recommended
that you use a 14 inch diameter (35.5 cm) or less Wok. It is recommended that you use the
POWER burner with the wok stand for best performance. If properly positioned, the Wok
Stand will not slide offthe grate.
To Properly Position the Wok Stand:
With the grate in position over the burner, set the Wok Stand on top of the
grate positioning the notches in the Wok Stand over the cooktop grate
fingers (See Figure 1).
Figure
Flat-bottom woks with large flat
bottoms may also be used on your
cooktop Surface Burner Grates
without the Wok Stand (See Figure
2). Insure the stability of the fiat-
bottom wok before cooking without
the Wok Stand. If unstable, DO
NOT use the flat-bottom wok
without the Wok Stand.
Round-bottom woks (with a
support ring) should NOT be
used (See Figure 3). The
supporting ring was not designed
for proper or stable use on the
Surface Burner Grates.
Proper use of fiat-bottom wok
on Surface Burner Grate
Figure 2
Improper use of round-bottom wok
on Surface Burner Grate
Figure 3