Download  Print this page

Settingsurfacecontrols - Electrolux EW30GC55GB1 Use & Care Manual

Hide thumbs

Advertisement

Surface Cooking
SETTING SURFACE CONTROLS
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
Your cooktop may be equipped with any combination of the following burners:
Simmer Burner: best used for simmering delicate sauces, etc.
Standard Burner: used for most all surface cooking needs.
Large Burner: best used when bringing large quantities of liquid to temperature and when
preparing larger quantities of food.
Regardless of size, always select a utensil that is suitable for the amount and type of food
being prepared. Select a burner and flame size appropriate to the pan. Never allow flames
to extend beyond the outer edge of the pan.
Your cooktop is also equipped with 270 ° rotation flame control valves. These valves
provide enhanced control of the burner flame. Each burner lights automatically
from an
electric ignitor when its control knob is turned to the LITE position.
To operate the surface burner:
1. Place cooking utensil on burner.
2. Push in and turn the Surface Control knob to J_v_(UTE). Note: All
electronic ignitors will click at the same time. However, only the burner
you are turning on will ignite.
3. Visually check that the burner has lit.
4. Turn the control knob to the desired flame size. The control knobs do
not have to be set at a particular mark. Use the guides and adjust the
flame as needed. DO NOT cook with the Surface Control knob in the
_:_,#4:#_
position. (The electronic ignitor will continue to click if left in the
position, causing premature wear.)
In the event of an electrical power outage, the surface burners can be lit
manually. To light a surface burner, hold a lit match to the burner head,
then slowly turn the Surface Control knob to _v,;;,.Use caution when
lighting surface burners manually.

Advertisement

loading

  Related Manuals for Electrolux EW30GC55GB1