Antenna Motor Installation - Nokia Mediamaster 9802 S Owner's Manual

FIRST TIME INSTALLATION
Motor antenna
In case you have an antenna motor to control your satellite an-
tenna you have to make the following settings. If the antenna is
prevented from reaching its predefined east/west limit positions,
you have to set new limits. See page 37 for instructions.
• From the "Antenna/Satellite selection" menu select line 7 (re-
fer to page 13) and press OK.
• Select line 5, "Motor antenna configuration" and press OK.
Type of motor
• Select SATSCAN if it is a Nokia SatScan motor.
• Select DiSEqC in case the motor you use is controlled by
DiSEqC commands.
LNB type
• Select Universal, one of the fixed frequencies or enter the LNB
frequency with the numeric buttons on the remote control.
LNB offset voltage
If the cable down from the antenna is very long, the voltage at
the LNB could be too low to change the polarization. You can in-
crease the voltage to the LNB by 0,5 Volt.
Satellite
Select Astra if you have a SatScan motor and Hotbird if you have
a DiSEqC motor.
GB 20