Advertisement
Assembte the spring tines with rod to the rear of the
tine shield using six 5/16" x 3/4" carriage bolts, tooth
lock washers, 5/16" lock washers and 5/t 6" hex
nuts. Ttghten,
See figure 3.
NOTE:
Tines must be seated between dimples.
5/16" HEX NUT'---_
5/16" LOCK WASHER _
TOOTH LOCK WASHER _'
SPRING TINE
t
5/16" x 3/4"
\
CARRIAGE BOLT
TINE SHIELD (FRONT)
FIGURE
3
Assemble the three angle brackets to the top of the
tine shield as shown in figure 4, using a 5/i6" x 3/4"
hex bolt, a 5/16" lock washer and a 5/16" hex nut for
each bracket.
NOTE: The slotted holes in the tine shield allow for
adjustment when mounting the de-thatcher to the
lawnsweeper.
5/16" x 3/4"
SLOTrED
HEX BOLT
HOLE
ANGLE
BRACKET._.=
HOLE
Assemble
the hftch arm mount brackets
to the top
of the tine shield using a 5/16" x 3/4" hex bolt, a
5/16" lock washer
and a 5/16" hex nut for each
bracket.
See figure 5.
5/16" x 3/4"
HEX
HITCH ARM
MNT. BRKT. "_
FIGURE
5
Assemble the hitch mount bars to the outside of the
angle brackets using two 5/16" x 3/4" he× bolts and
two 5/16" hex lock nuts. Fasten through the slotted
holes in the bars, Tighten so that the bars can pivot.
See figure 6.
Assemble the hitch mount bars to the hitch arm
mount brackets using two 5/16"x
1" carriage bolts,
tooth lock washers, 5/16" lock washers and 5/16"
hex nuts. (Be sure to place the tooth lock washer
between the hitch mount bar and the hitch arm
mount bracket.) See figure 6.
HITCH MOUNT BAR
ANGLE BRACKET
5/16" x 3/4"
HEX BOLT
5/16" HEX
LOCK NUT
5/16" LOCK
WASHER
5/16" HEX NUT
;" xl"
CARRIAGE BOLT
HITCH ARM
MNT. BRKT.
TOOTH LOCK WASHER
FIGURE
4
FIGURE
6
Advertisement
