Safety Symbols - Craftsman 320.21228 Operator's Manual

Recommended size of extension cords
Amperage rating
More than Not more than
0 6
6 10
10 12
12 16
Volts Total length of the extension cord
120v 25ft. 50ft. 100ft. 150ft.
240v 50ft. 100ft. 200ft. 300ft.
Minimum Gauge for the extension cord (AWG)
18 16 16 14
18 16 14 12
16 16 14 12
14 12 Not recommended
,&
WARNING: Ensure that the power-supply outlet in question is properly
grounded. If not certain, have a licensed electrician check the outlet.
,_ WARNING: To avoid electrical hazard, fire hazards, or damage to the tool,
use proper circuit protection.
SAFETY SYMBOLS FOR YOUR TOOL
The label on your tool may include the following symbols:
V ........................................... Volts
A .......................................... Amps
Hz ......................................... Hertz
W .......................................... Watts
Min ....................................... Minutes
'_ ....................................... Alternating current
........................................ Direct current
no ........................................ No-load speed
[] ......................................... Class II construction, Double Insulated
.../min .................................... Revolutions or Strokes per minute
_, ........................................ Indicates DANGER, WARNING or CAUTION:
ATTENTION! Your safety is involved!
SERVICE SAFETY
• If any part of this saw is missing or should break, bend, or fall in any
way; or should any electrical component fall to perform properly: shut
off the power switch, remove the plug from the power source, and have the
missing, damaged or failed parts replaced before resuming operation.
• Tool service must be performed only at a Sears Parts and Repair Center.
Service or maintenance performed by unqualified personnel could result in a
risk of injury.
21228 Manual Revised 08-0307 Page 8