Craftsman 320.21228 Operator's Manual page 20

8. With one foot still on the Base Bar, lower the Tabletop Assembly onto the Support
Bar (8), while making sure that the Support Bar is placed into the Notch (Fig. 10).
9. Pull the Spring-Loaded Locking Pin back, so that the Support Bar and
Tabletop groove fit together securely, and then release the Spring-Loaded
Locking Pin so that the Tabletop locks into position (Fig. 11).
10. To change the width of the Tabletop Assembly working area, turn the two
Clamp Knobs clockwise to unlock them, as shown in Fig. 12.
Fig. 11
11. After loosening the Clamp Knobs (Fig. 13), adjust the Tabletop Assembly to
the desired position to mount the power tool, as shown in Fig. 13 and 14.
12. Be sure that, after adjusting the width of the Tabletop Assembly, the two
Clamping Knobs are locked: turn them until they are securely tightened (Fig. 15).
Fig. 13 Fig.
J,
//
Fig. 15, _ /
21228 Manual Revised 08-0307 Page 20