DCS DishDrawer DD224P5 Use And Care Manual page 27

Fault codes
How to recognize a fauJt code
When a fault has occurred, the DishDrawer _ will continuously beep every second.
The fault code will be displayed on the wash program selector.
Each fault code is shown in the following chart.
How to attend to a fault code
1 Press the O button to remove the fault code.
2 If the fault code and continuous beeps cannot be removed by pressing the O button, turn the
DishDrawed _ off at the power supply.
3 We recommend you check the following chart and correct the fault where possible.
4 After attending to the fault, turn the DishDrawed _ on at the power supply.
5 If the fault code and continuous beeps remain, turn the water and power supply off to the
DishDrawedL
6 When calling your Authorized Service Center advise them of the fault code that has appeared
on the DishDraweCL This information will help the Authorized Service Center respond to your
request.