DCS DishDrawer DD224P5 Use And Care Manual page 19

Rinse agent dispenser
We highly recommend the regular use of liquid rinse agent to give the best drying results, Rinse
agent gives a streak free, sparkBing dean look to gBass and chinaware, in addition it
prevents metal from tarnishing. The rinse agent dispenser is on the inside of each drawer,
located underneath the detergent dispenser. The dispenser holds approximately 1.7 fl oz (50 ml)
of rinse agent.
Filling t he rinse agent dispenser
1 Turn the plug counter-clockwise and remove.
2 Pour the rinse agent into the circular opening.
3 Take care not to spill rinse agent into the
DishDraweP. Any spillages must be wiped up to
prevent excess foaming. Failure to wipe rinse agent
spillages may result in a service call which will not be
covered by warranty.
4 Fit the plug back into the original position.
How much rinse agent to use
The regulator may need adiusting to suit your water conditions. The lowest setting is'l'and
the highest is'S'. Refer to Option Adiustments section to adiust the rinse agent setting. If there
is excessive foam at the end of the wash, reduce the setting. If dishes are wet or streaky after
drying, increase the setting.
Rinse agent indicator light
If the rinse agent indicator light is red, refill the dispenser. If the rinse agent indicator light is
dimly lit or not lit at all, there is enough rinse agent for the wash,
Note:
Lighter colored rinse agents will not dim the indicator light as effectively as darker colored rinse
agents.
When the rinse agent is being dispensed, you may notice some unusual noises during the wash,
this is normal