Installation - SATO M-84Pro Series Quick Manual

M-84PRO Quick Guide
PRINT-OUTS
Vector Fonts
Font Size 50 x 50 dots to 999 x 999 dots
Rotation
Graphics Dot addressable, SATO Hex/Binary, BMP or PCX formats
SPECIFICATION
CONTROLS AND INDICATORS
Power
On-Line
Label
Ribbon
Error
LCD Panel
Label Feed
Power On/Off Switch
POTENTIOMETER ADJUSTMENTS
Print Darkness
Offset
Pitch
Display
INTERFACE CONNECTIONS
Parallel
Serial
Universal Serial Bus
Ethernet
PROCESSING
CPU
Flash ROM
SDRAM
Receive Buffer
Memory Expansion
Proportional or Fixed Spacing
Helvetica, 10 Font Variations
0º , 90º , 180º , and 270º Rotation
M-84PRO All Models
Green LED
Green LED
Red LED
Red LED
Red LED
2 Line x 16 Character
Front Panel
Front Panel
Front Panel
Front Panel
Font Panel
Front Panel
IEEE1284 Standard
RS232C (9600 to 57600 bps) Standard
RS422/485 (9600 to 57600 bps) Optional
Ready/Busy or X-On/X-Off Flow Control
Bi-directional Status
USB Ver. 1.1 Standard
10/100 BaseT
32 Bit RISC
2 MB
16 MB
2.95 MB
See Options and Accessories
Pg 21 M-84PRO Quick Guide

Installation

Remove the M-84PRO from the packing container. Check to make sure you have the
following:
Careful consideration must be given when selecting the location of the printer, especially to
environmental considerations. To obtain optimum results from M-84PRO, always try to avoid
operation locations influenced by:
•
Direct or bright sunlight, as this will make the label sensor less responsive and may
cause the label to be sensed incorrectly.
•
Locations which have extreme temperature, as this can create electrical problems on
the circuits within the printer.
•
The installed location of the printer should ideally be in areas free from dust,
humidity and sudden vibrations.
Consumables
Always use SATO carbon ribbons and labels or equivalent in the thermal transfer models.
The use of incorrect materials may cause malfunctions of the printer and void the printer
warranty.
Quick Guide
Pg 2